Sim2 HT200 DMF Uživatelský manuál

USER AND INSTALLATIONMANUALENGLISHHT 200 DMF

105 CONNECTIONSThis input is suitable for equipment fitted with a S-Video outputto give improved picture performance (S-VIDEO/S-VHS)Connection is ma

11ENGLISHREMOTE INPUT INTERFACE CONNECTING CABLEWith a special cable (optional), it is possible to connect the Re-mote Input Interface (optional) to t

126 KEYBOARD PADUp/Down/Left/Right arrow keysNavigate through and make adjustmentsto the On Screen menus.Arrow Up/Down switch on from stand-byand r

13ENGLISHNot activein this model.MENU -Activates the On ScreenDisplay menus.Navigates menu pages.FREEZEFreezes a movingpicture.FOCUSSelects focuslens

148 ON SCREEN MENUSFig. 29PICTUREThis menu features adjustments relating to the projected imagequality.BRIGHTNESSCONTRASTCOLORSHARPNESSFILTER2050507

15ENGLISHTINTControls the purity of the colours, to NTSC coded signalstandards. Tint is only applicable to video input with NTSCstandard, to RGB 15kHz

16User 1, 2, 3Should you wish to use a format different to those preset, go toUser menus.ASPECT / USER 1HORIZONTALVERTICALSCREEN CONTROL0-10OnOffBy us

17ENGLISH(the magnifying lens icon will appear at the centre of theimage).Select Pan (zoom button on the remote control) to choosethe area of imag

18TEST PATTERNSDisplays a series of five test patterns, useful for the installationof the projector.Press Up and Down Arrow keys to browse pattern.FA

19ENGLISH10 TROUBLESHOOTING GUIDEspecifications of the projector.- Check the integrity of cables used to connect various sources.- If you are using

!CAUTIONRISK OF ELECTRIC SHOCK!DO NOT REMOVE THE TOP COVERPrior to switching on the projector please read each chapter of this manual carefully as thi

20adjustments.- Adjust the horizontal and vertical position of projected imageby selecting Position on the Image Adjustments menu.- Adjust the width

21ENGLISHA TECHNICAL SPECIFICATIONSGraphic standards : VGA, SVGA, XGA, SXGA, UXGADeinterlacer: Faroudja chip set, DCDi™, 3:2 pulldown sequence conve

22B PROJECTION DISTANCESFollow the table below to determine the optimal projection distance (between the screen and the center of the lens). This wi

Table of contentsIMPORTANT SAFETY INSTRUCTIONS ... 41 PACKAGING AND CONTENTS...

4IMPORTANT SAFETY INSTRUCTIONSsensitive to heat, as this may result in damage caused by thehot air outlets underneath. Should this be unavoidable take

5ENGLISHFig. 5The new DMD™ chip provide two different functioning modes:4:3 mode (4:3 aspect: 800x600 active pixels) and 16:9 mode(16:9 aspect: 848x48

61 Projection lens2 Lens shift knob.3 Cooling air inlet vents.4 Remote control IR sensor.5 Cooling air outlet vents.6 Adjustable carry-handle.7 Adjust

7ENGLISH••••• 4:3 SCREEN. If the 16:9 mode is selected, the black bar abovethe image will have a greater area than the black bar below theimage (Fig.

8Fig. 14For rear projection the screen must be translucent.For front projection, we recommend the use of screens with lowgain specifications (i.e. 1.3

9ENGLISHSWITCH ON FROM STAND-BYBy remote control: press one of 1...9By keyboard: press Up or Down Arrow .Fig. 17When switching on from stand-by, the p